Welcome to our websites!
Technical Information
-
Selection of sanding belt
he structure of sander belt Based on the analysis of material mechanics, the overall mechanical strength of an object is homogeneous, and its physical and chemical properties should be similar. The mechanical strength of objects composed of more than two units of the same material should be no le...Read more -
How to operate the sander correctly
When the sanding machine is in operation, due to improper operation, the machine will show minor defects, and we need to clean it in time. If the disposal is not timely or improperly, it may affect consumption. Therefore, there are strict requirements for technicians, and they must familiarize th...Read more -
Analysis on the specific use of sanding machine
Like other mechanical equipment, woodworking sanding machines often show some defects during operation, but these should be removed in time, but if they are not handled properly, they may affect consumption and increase costs. This requires that the operator must be familiar with the operation re...Read more -
Introduce the characteristics of the special-shaped sanding machine
Nowadays, the use of special-shaped sanding machines is more and more common, and our special-shaped sanding machines are used more and more widely. Regarding us, after receiving the goods, we must be careful when checking, not to hurt ourselves, and to check carefully. See if there are any probl...Read more -
Specific introduction to the use of sanding machine
Pre-job request: The use of sanding machine equipment should adopt the method of fixed-person and fixed-post, and pre-job training should be stopped before the operator starts to learn the equipment performance. The equipment shall not be used after the brake fails, and shall be reported to the e...Read more -
Different USES of Sander
In this type of broad - band sander, it is easy to appear the problem is the sand belt deviation. This is caused by improper adjustment of the original belt, of course, if the dust concentration of the outside is too high, the flowers will also cause shadow to the sander...Read more
